Long press
Hold BACK for about 3 seconds.
Single-axis returns H to Home. Dual-axis returns both axes to Home.
AntennaPilot Controller without Ethernet
Quick Start
- The controller operates the antenna system over RS485.
- It detects single-axis and dual-axis devices automatically.
- The joystick moves the antenna manually.
- BACK returns the device to Home or exits a menu.
Basic Principle
- Move the antenna with the joystick.
- Use BACK to return to Home.
- Hold the joystick to open settings.
- Use Save & Exit after changing settings.
Warning
Do not switch power off immediately after movement.
Wait at least 3-5 seconds after movement so the device can save the current position.
Main Controls
| Control | Purpose |
|---|---|
| Joystick | Manual antenna movement. |
| Joystick press | Open menu, select item, confirm value. |
| BACK | Return to Home or go back in menus. |
| Speed switch | Force fast speed mode. |
Manual Control
- Move the joystick horizontally to control H.
- On dual-axis devices, the second joystick axis controls V.
- Stronger deflection means higher movement speed.
| Axis | Speeds |
|---|---|
| H | LOW: 1,3,5 · HIGH: 1,5,10 |
| V | 1, 3, 6. |
Settings Menu
✓ Set X(H) pos — set current horizontal position.
✓ Set Y(V) pos — set current vertical position on dual-axis devices.
✓ Set L/R limits — configure horizontal movement limits.
✓ Set H/V home — configure Home position.
✓ Speed mode — choose LOW or HIGH speed profile.
✓ Save & Exit — save changes.
Control Mode
Control mode changes how the controller reacts to joystick movement.
✓ ORIGINAL — speed immediately follows joystick deflection.
✓ MODIFIED — softer start with gradual speed increase.
✓ FIXED — joystick sets direction; speed comes from Fixed H/V speed settings.
✓ Ramp delay sets soft-start delay in MODIFIED:
1 to 5 seconds.BACK Button
Short press
Opens the quick menu.
On dual-axis devices, use H axis only, V axis only or Both axes.
Service Messages
| Message | Meaning | What to do |
|---|---|---|
NO CONNECTION | No connection to the device. | Check power, cable and RS485 connection. |
VER. MISSMATCH! | Controller and device protocol versions differ. | Use compatible firmware versions. |
UNKNOWN DEVICE | Unknown device connected. | Check device type and compatibility. |
BLOCK! | Axis blocked or stall detected. | Check mechanics, obstacles and load. |