AntennaPilot Manual

Power from a 6S battery with XT60 connector, 20-24 V.
It may start from 12 V, but stable operation is not guaranteed and the position may be lost.
Quick mounting and removal without needing tools at hand.
Compatible with mast tubes from 25 to 40 mm.

Warning

Do not connect or disconnect the cable between devices while powered.

Connect all cables first, tighten the connectors, and only then apply power.

Mount the rotating unit on the mast and tighten the clamp.

Install the tube into the rotating unit and secure it.

Connect the cables to the rotating unit and tighten the GX16 connectors.

Connect the other end of the cable to the controller and tighten the connector.

Connect 24 V power from the 6S battery through the XT60 extension cable.

Turn on the controller and wait a few seconds for connection.

The battery is connected to the controller, not directly to the rotating head.

Move the joystick left or right to rotate the antenna horizontally.
Horizontal speed: 1, 3, 5 deg/s or 1, 5, 10 deg/s, depending on Speed mode.
Vertical speed: 1, 3, 6 deg/s.

Menu item	Purpose
Set X (H) pos	Set the absolute azimuth value.
Set Y (V) pos	Set the absolute tilt value.
Set L/R limits	Set left and right rotation limits.
Set H home	Set the horizontal home position.
Set V home	Set the vertical home position.

After the last movement, wait at least 3 seconds before switching power off.

The current position is saved automatically after the movement stops.

If power is switched off too early, the current position may not be saved.

The LED is on while the controller is moving or the position is not saved yet.

Hold the BACK button for about 3 seconds.

The device returns to the configured Home position.

Works as Back in menus.

On dual-axis devices, you can return H only, V only, or both axes.